Jabra JX10 Black 用户手册
4
En
gli
sh
5
En
gl
is
h
5
4
2
3
How to…
Answer a call
• Tap the answer/end button on your headset to answer a call.
End a call
• Tap the answer/end button to end an active call.
Make a call
• When you make a call from your mobile phone, the call will (subject to phone
settings) automatically transfer to your headset. If your phone does not allow
this feature, tap on the Jabra JX0’s answer/end button to transfer the call to the
headset.
Reject a call*
• Press the answer/end button when the phone rings to reject an incoming call.
Depending on your phone settings, the person who called you will either be
forwarded to your voice mail or hear a busy signal.
Activate voice dialing*
• Tap the answer/end button. For best results, record the voice-dialing tag through
your headset. Please consult your phone’s user manual for more information about
using this feature.
Redial last number*
• Press the answer/end button.
Adjust sound and volume
• Press the volume up or down (+ or -) to adjust the volume. (See fig. 1 )
Call waiting and placing a call on hold*
This lets you place a call on hold during a conversation and answer a waiting call.
• Press the answer/end button once to put the active call on hold and answer the
waiting call.
• Press the answer/end button to switch between the two calls.
• Tap the answer/end button to end the active conversation.
* Functions marked with * are dependent on your phone supporting these
features. Check your phone’s user manual for further information.
Turning your headset on and off
• Press the answer/end button to turn on your headset. The blue light (LED)
shows a burst of flashes and thereafter continues to flash every 3 seconds.
• To turn off your headset, press and hold the answer/end button until you see a burst
of flashes.
Pair it with your phone
Before you use your Jabra JX10, you need to pair it with your mobile phone.
1. Put the headset in pairing mode
• Make sure the headset is on.
•
Press the pairing button marked until the blue light (LED) turns solid blue.
2. Set your Bluetooth phone to ‘discover’ the Jabra JX10
Follow your phone’s instruction guide. This usually involves going to a ‘setup,’
‘connect’ or ‘Bluetooth’ menu on your phone and selecting the option to ‘discover’ or
‘add’ a Bluetooth device. * (See example from a typical mobile phone in fig. 6).
3. Your phone will find the Jabra JX10
Your phone then asks if you want to pair with it. Accept by pressing ‘Yes’
or ‘OK’ on the phone and confirm with the
passkey or PIN = 0000 (4 zeros).
Your phone will confirm when pairing is complete. In case of unsuccessful pairing,
repeat steps to 3.
Wear it how you like it
The Jabra JX0 is ready to wear on your right ear. If you prefer the left, gently remove the
earhook and rotate to fit the left ear. (See fig. 4)
For optimal performance, wear the Jabra JX0 and your mobile phone on the same
side of your body or within line of sight. In general, you will get better performance
when there are no obstructions between your headset and your mobile phone.