Indesit H571 IX 用户指南

下载
页码 12
Consult  the  designs  in  the  front  pages  referenced  in  the  text  by
alphabet  letters.    Closely  follow  the  instructions  set  out  in
this  manual.  All  responsibility,    for  any  eventual  inconveniences,
damages  or  fires  caused  by  not  complying  with  the  instructions
in  this  manual,    is  declined.
Installation
The  cooker  hood  must  be  placed  at  a  minimum  distance  of
60  cm  from  the  cooking  plane  for  electric  cookers  and  70cm
for  gas  or  mixed  cookers.
Do  not  tile,  grout  or  silicone  this  appliance  to  the  wall.  Surface
mounting  only.
Do  not  fix  chimney  flue  to  furniture  or  fly  over  shelves  unless
the  chimney  flue  can  be  easily  removed,  in  case  maintenance
is  ever  required.
Use
The  cooker  hood  is  provided  with  an  upper  air  exit  B  for
discharging  fumes  externally  for  models  including  chimney
flue  C  (  Suction  Version  A-  exhaust  pipe  13A  not  supplied).
In  the  instance  where  it  is  not  possible  to  discharge  cooking
fumes  and  vapours  externally  even  if  utilising  the  model  with
chimney  flue  C,    the  cooker  hood  may  be  used  in  the  filter
version  F  by  mounting  two  active  carbon  filters  E,  the  fumes
and  vapours  are  then  recycled  via  the  upper  grill  G.
Electrical  connection
The  electrical  tension  must  correspond  to  the  tension  noted
on  the  label  placed  inside  the  cooker  hood.  Connect  the
electrical  plug,  where  provided,  to  the  an  easily  accessible
outlet  in  conformity  with  local  standards  in  force.
Where  an  electrical  plug  is  not  provided  (for  direct  connection
to  electrical  network)  place  a  standards  approved  bipolar
switch  with  an  aperture  distance  of  not  less  than  3mm
(accessible)  from  the  contacts.
Operation
The  cooker  hood  is  provided  with  a  key  or  pushbutton  control
panel  situated  of  the  frontal  part  of  the  cooker  hood,  depending
on  the  basis  of  the  cooker  hood  type  in  possession.    For
proper  operation  consult  the  text  below  and  the  relative
illustration:
a.  ON/OFF  lighting
b.  OFF  motors
c.  -  d.  -  e.  Minimum  suction  power  (c.),  medium    (d.),
maximum  (e.).
a
b-c-d-e
Use  the  high  suction  speed  in  cases  of  concentrated  kitchen
vapours.    It  is  recommended  that  the  cooker  hood  suction
is  switched  on  for  5  minutes  prior  to  cooking  and  to  leave
in  operation  during  cooking  and  for  another  15  minutes
approximately  after  terminating  cooking.
Maintenance
Prior  to  any  maintenance  operation  ensure  that  the  cooker
hood  is  disconnected  from  the  electrical  outlet.
Cleaning
The  cooker  hood  should  be  cleaned  regularly  internally  and
externally.
For  cleaning  use  a  cloth  moistened  with  denatured  alcohol
or  neutral  liquid  detergents.    Avoid  abrasive  detergents.
Warning:
Failure  to  carry  out  the  basic  standards  of  the  cleaning  of  the
cooker  hood  and  replacement  of  the  filters  may  cause  fire
risks.  Therefore  we  recommend  oserving  these  instructions.
Metallic  anti  grease  filter  must  be  cleaned  once  a  month,
with  non  abrasive  detergents,    by  hand  or  in  dishwasher  on
low  temperature  and  short  cycle.
This  filter  should  be  removed  from  its  placing  by  pushing  the
handles  O  towards  the  back  and  sliding  the  filter N downwards.
When  washed  in  a  dish-washer,  the  grease  filter  may
discolour  slightly,  but  this  does  not  affect  its  filtering  capacity.
Carbon  Filter
(2  pieces  –  only  for  filter  version)
The  active  carbon  filters  E  are  not  washable  nor  regenerative.
It  should  be  changed  every  6  months  in  normal  use.
The  active  carbon  filters  capture  unpleasant  cooking
odours.
Apply  one  on  each  side  covering  both  grills  protecting  the
motor  propeller,  then  turn  the  filter  central  handles  P  clockwise.
In  order  to  dismantle  turn  the  central  handle  P  anti-clockwise
for  each  filter.
Replacing  lightbulbs
Remove  the  anti-grease  filter  support  grill  or  the  anti-grease
filter  to  attain  access  to  the  lightbulb  area.    Remove  the
damaged  lightbulb  and  replace  with  an  incandescent  oval
bulb  max.  40W  E14.
If  the  cooker-hood  comes  with  a  halogen  light,  take  off  its
protection  by  unscrewing  (Z1)  or  by  removing  it  (Z2  lifting
with  a  small  flat  edged  screwdriver).  Remove  the  damaged
bulb  and  substitute  it  with  a  max  20W  halogen  bulb  (G4).
Caution
This  appliance  is  designed  to  be  operated  by  adults.  Children
should  not  be  allowed  to  tamper  with  the  controls  or  play  with
the  appliance.
Do  not  use  the  cooker  hood  where  the  grill  is  not  correctly
fixed!    The  suctioned  air  must  not  be  conveyed  in  the  same
channel  used  for  fumes  discharged  by  appliances  powered
by  other  than  electricity.    The  environment  must  always  be
adequately  aerated  when  the  cooker  hood  and  other
appliances  powered  by  other  than  electricity  are  used  at  the
same  time.      Flambé  cooking  with  a  cooker  hood  is
prohibited.  The  use  of  a  free  flame  is  damaging  to  the  filters
and  may  cause  fire  accidents,  therefore  free  flame  cooking
must  be  avoided.    Frying  of  foods  must  be  kept  under  close
control  in  order  to  avoid  overheated  oil  catching  fire.  Carry
out  fumes  discharging  in  accordance  with  the  regulations  in
force  by  local  laws  for  safety  and  technical  restrictions.
INSTRUCTION  ON  MOUNTING  AND  USE
GB