Snapper MZM2200KH 用户手册

 

1.  Front Wheel Bearings 
Lubricate with Kendall NLGI No. 2 lithium 
grease or equivalent, from a grease gun.  
See Figure 3.5. 

 

2. Transaxle 
Check the level of fluid in both of the fluid 
reservoirs. Wipe away all dirt and debris from 
around reservoir cap before removing. Oil 
must remain absolutely clean! Check with 
machine on a level surface with engine 
“OFF”. Fill reservoir as needed to bring 
level up to 1-1/2 inches below the top of the 
filler neck.  Use clean, fresh premium 
hydraulic oil having a viscosity equivalent to 
SAE 20W20, SAE 30 or SAE40. The fluid 
should be chemically stable, incorporating rust 
and oxidation inhibitors. Make sure funnels, 
pouring spouts and oil can are completely 
clean. Reinstall reservoir cap. See Figure 3.6. 
IMPORTANT: DO NOT remove or service 
the transaxle fluid filters. This service should 
be made periodically by an authorized 
SNAPPER dealer. See the service schedule 
to determine the recommended change 
interval. 
 
 

 

3.  Power Transfer Shaft 
Lubricate power transfer shaft with Kendall 
NLGI No. 2 lithium grease or equivalent, 
from a grease gun.  See Figure 3.7. 

 

 

 

4.  OTHER LUBRICATION POINTS 
Lubricate machine caster wheel shafts, 
traction drive shaft and mower deck idler 
arm with Kendall NLGI No. 2 lithium grease 
or equivalent, from a grease gun. 

 
3.4  BEFORE OPERATING MACHINE 

1. Clean all dirt and debris from around the two 
hydraulic fluid reservoirs. Especially around the top 
and cap area. 
2.  Clean all dirt and debris from the cooling fins on 
the engine and from both hydraulic pumps. 
 

Perform all maintenance as described in Section 
“AFTER EVERY 25 OPERATING HOURS”.  
 
3.5.1. ENGINE 
Service engine according to engine owner’s manual. 

 

(Continued on next Page)