Empire Comfort Systems PV-28SV50-B2H(N,P)-1 用户手册

24820-1-0409

Page 46

Remove main burner and apply air pressure inside the throat and 

ports of the main burner.

1.  Remove front door assembly. See Figure 55.

2.  Remove logs from firebox.

3.  Remove  installation  bracket  and  gasket  from  underside  of 

firebox (1 screw).

4.  Disconnect flame sensor and HSI connector from wiring har-

ness.

5.  Remove log support from inside firebox (13 screws).

6.  Remove HSI from log support (13 screws).

7.  Remove flame sensor from log support (1 screw).

8.  Remove burners from firebox (1 screw).

9.  Once burners are removed, orifices are exposed.

It will be necessary to clean the glass periodically. During start-

up,  condensation,  which  is  normal,  forms  on  the  inside  of  the 

glass and causes lint, dust and other airborne particles to cling to 

the glass surface. Also, initial paint curing may deposit a slight 

film on the glass. It is therefore recommended that the glass be 

cleaned two or three times with a non-abrasive household cleaner 

and warm water (we recommend gas fireplace glass cleaner) after 

the initial burn. We do not recommend using packaged spray type 

household glass cleaner. After that, the glass should be cleaned 

two or three times during each heating season depending on the 

circumstances present.
General Glass Information

Only glass approved for use in Empire Comfort Systems, Inc. fire-

place may be used for replacement. The glass replacement must 

be done by a licensed or qualified service person.
WARNING: 

1.  The use of substitute glass will void all product warranties.

2.  Care must be taken to avoid breakage of the glass.

3.  Under  no  circumstances  should  this  appliance  be  operated 

without the glass front or with a broken glass front. Replace-

ment of the glass (with gasket) as supplied by the manufac-

turer must be done by a qualified service person.

4.  Do not abuse the glass by striking or hitting the glass.

1.  Remove cabinet top.

2.  Pivot left and right front panels open.

3.  Release two door latches on left and right of firebox.

4.  Grasp glass frame and carefully pull toward you.

5.  Place glass frame assembly on non-abrasive surface. The ex-

terior of the glass frame assembly should be facing the non-

abrasive surface.

6.  Insert  a  putty  knife  between  glass  and  bottom  corners  on 

frame. Carefully separate glass from frame.

7.  Use putty knife to remove silicone and gasket material from 

frame. Surface of frame must be clean and dry.

8.  At each corner of frame apply two (2) three inch beads of 

high temperate (orange) silicone.

9.  With  thin  gasket  on  glass  facing  silicone  on  frame,  insert 

glass into frame. Carefully press the glass onto frame in order 

to have contact between glass and silicone.

10.  Allow silicone to set-up for an adequate time.

11.  Gently place glass frame back into firebox.

12.  Close the 2 door latches on left and right of firebox.

13.  Pivot left and right front panels closed.

14.  Replace cabinet top.