Husqvarna 575XP 用户手册

34 – 

English

•

Loosen the screws that hold the starter against the 
crankcase and remove the starter.

•

Pull out the cord approx. 30 cm (12 inches) and hook it 
into the notch in the rim of the pulley. Release the recoil 
spring by letting the pulley rotate slowly backwards.

•

Undo the screw in the centre of the pulley and remove the 
pulley. Insert and fasten a new starter cord to the pulley. 
Wind approx. 3 turns of the starter cord onto the pulley. 
Connect the pulley to the recoil spring so that the end of 
the spring engages in the pulley. Fit the screw in the 
center of the pulley. Insert the starter cord through the 
hole in the starter housing and the starter handle. Make a 
secure knot in the end of the starter cord.

•

Hook the starter cord in the notch in the pulley and turn 
the starter pulley about 2 turns clockwise. 

Note! Check that the pulley can be turned an additional 1/
2 turn when the starter cord is pulled all the way out.

•

Lift off the pulley. See instructions under heading 
Changing a broken or worn starter cord.

•

Remove the recoil spring from inside the pulley by tapping 
the pulley lightly with its inside face downwards against a 
work bench or the like. If the spring pops out during fitting, 
wind it up again, working from the outside in towards 
centre.

•

Lubricate the recoil spring with light oil. Fit the pulley and 
tension the recoil spring.

•

To fit the starter, first pull out the starter cord and place the 
starter in position against the crankcase. Then slowly 
release the starter cord so that the pulley engages with 
the pawls.

•

Fit and tighten the screws that hold the starter.