Husqvarna 345 用户手册

English

 – 33

•

Undo the screw in the centre of the pulley and remove the 
pulley. Insert and fasten a new starter cord to the pulley. 
Wind approx. 3 turns of the starter cord onto the pulley. 
Connect the pulley to the recoil spring so that the end of 
the spring engages in the pulley. Fit the screw in the center 
of the pulley. Insert the starter cord through the hole in the 
starter housing and the starter handle. Make a secure 
knot in the end of the starter cord.

•

Hook the starter cord in the notch in the pulley and turn the 
starter pulley about 2 turns clockwise.

Note! Check that the pulley can be turned an additional 1/
2 turn when the starter cord is pulled all the way out.

•

Lift up the starter pulley. See instructions under the 
heading Changing a broken or worn starter cord. 
Remember that the recoil spring is coiled under tension in 
the starter housing.

•

Remove the cassette with the recoil spring from the 
starter.

•

Lubricate the recoil spring with light oil. Fit the cassette 
with recoil spring in the starter. Fit the starter pulley and 
tension the recoil spring.

•

Undo the bolt in the centre of the pulley and remove the 
drive disc and the drive disc spring.

•

Replace the drive disc spring and fit the drive disc above 
the spring.

•

To fit the starter, first pull out the starter cord and place the 
starter in position against the crankcase. Then slowly release 
the starter cord so that the pulley engages with the pawls.

•

Fit and tighten the screws that hold the starter.

The air filter must be regularly cleaned to remove dust and dirt 
in order to avoid:

•

Carburettor malfunctions

•

Starting problems

•

Loss of engine power

•

Unnecessary wear to engine parts

•

Excessive fuel consumption.

•

Remove the air filter after taking off the air filter cover. When 
refitting make sure that the air filter seals tightly against the 
filter holder. Clean the filter by brushing or shaking it.

The filter can be cleaned more thoroughly by washing it in 
water and detergent.

An air filter that has been in use for a long time cannot be cleaned 
completely. The filter must therefore be replaced with a new one at 
regular intervals. A damaged air filter must always be replaced.

A HUSQVARNA chain saw can be equipped with different 
types of air filters according to working conditions, weather, 
season, etc. Contact your dealer for advice.