Husqvarna 346XP EPA II 用户手册

14 – 

English

•

Check the chain lubrication each time you refuel. 

Aim the tip of the bar at a light coloured surface about 20 
cm (8 inches) away. After 1 minute running at 3/4 throttle 
you should see a distinct line of oil on the light surface.

If the chain lubrication is not working:

•

Check that the oil channel in the bar is not obstructed. 
Clean if necessary.

•

Check that the groove in the edge of the bar is clean. 
Clean if necessary.

•

Check that the bar tip sprocket turns freely and that the 
lubricating hole in the tip sprocket is not blocked. Clean 
and lubricate if necessary.

If the chain lubrication system is still not working after carrying 
out the above checks and associated measures you should 
contact your service agent.

Lubricate the bar tip sprocket each time you refuel. Use the 
special grease gun and a good quality bearing grease.

The clutch drum is fitted with one of the following drive 
sprockets:

A   Spur sprocket (the chain sprocket is welded on the drum)

B   Rim sprocket (replaceable)

Both versions have a needle bearing on the drive shaft, which 
has to be greased regularly (once a week). CAUTION! Use 
only high quality bearing grease or engine oil.

Check the chain daily for:

•

Visible cracks in rivets and links.

•

Whether the chain is stiff.

•

Whether rivets and links are badly worn.

We recommend you compare the existing chain with a new 
chain to decide how badly the existing chain is worn.

When the length of the cutting teeth has worn down to only 4 
mm the chain must be replaced.

The clutch drum is fitted with one of the following drive 
sprockets:

A   Spur sprocket (the chain sprocket is welded on the drum)

B   Rim sprocket (replaceable)

Regularly check the degree of wear on the drive sprocket. 
Replace if wear is excessive. Replace the drive sprocket 
whenever you replace the chain.