Husqvarna 346XP EPA II 用户手册

English

 – 37

Following is a list of recommended cutting equipment for the Husqvarna chain saw models 346XP and 353. The combinations of 
power head, bar and chain have been investigated in accordance with the kickback and vibration requirements of ANSI B 175.1–
2000.

The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding 
maximum nose radius of a solid bar.

The following list is the chain saw manufacturers recommendations. There may be other combinations available, which will also 
achieve kickback reduction.

As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide 
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be 
considered to have equivalent kickback energy. A hard nose bar having the same length and nose radius as a sprocket-nose bar 
may be considered to have equivalent or less kickback energy than the sprocket-nose bar.

Low kickback saw chain is a chain which has only met the kickback performance requirements of ANSI B 175.1 safety requirements 
for gasoline powered chain saws when tested on the representative sample of chain saws below 3.8 cu. in. specified in ANSI 175.1. 
We recommend that you as a replacement use the listed chains or "Low kickback saw chains" which are available at your dealer.

Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding bar, see the 
table below.

13

0,325

10T

Husqvarna H30, Oregon 95VP

15

0,325

10T

16

0,325

10T

18

0,325

10T

20

0,325

10T

13

0,325

10T

Husqvarna H25, Oregon 
21BP/34LG or 34SL (not 13”)

15

0,325

10T

16

0,325

10T

18

0,325

10T

20

0,325

12T

-

-

H25

21BP

34LG

34SL

H30

95VP

-

20BP

33LG

33SL

L