Husqvarna 170BT 用户手册

English

CONTROL ARM [170BF]

• Hold the upper end of the control arm in hand and, while pulling it away from the unit,

rotate arm forward (counter-clockwise in the direction of the arrow) until it clicks.
(The first position)
And if you want, you can rotate arm further until it clicks. (The second position)
Choose the arm position according to your working condition.

• To fold the arm, reverse the order.

(1) First position
(2) Second position

STARTING ENGINE

IMPORTANT

• Avoid operating the blower with the flexible tube and swivel joint

disconnected. That will reduce the cooling air and the engine could be
damaged by overheating.

1. Push the primer bulb until fuel flows out in the clear tube.
2. When the engine is cool, close the choke.

(1) Choke Lever
(2) Primer Bulb
(3) OPEN
(4) CLOSE

3. Set the throttle lever in about 1/3 open position.

(1) Full Throttle
(2) About 1/3 Open
(3) Idling
(4) STOP
(5) Stop Switch

4. To start, hold the top of the blower firmly with your left hand. Pull the starter knob

slowly until you feel it engage and then give it a vigorous strong pull.

IMPORTANT

• Never twist the starter cord around your hand.
• Avoid pulling the starter rope out to its full extent and allowing the starter rope

to snap back. This will prevent premature damage to the starter.

• Do not let a person stand near the blower or the exhaust port.

5. Once the engine is running, gradually open the choke if it was set closed, and let the

engine run at idle speed for a minute to warm it up.

NOTE

When the engine fails to start after several attempts due to overchoking, open
the choke and repeat pulling the rope.

WARNING

Air comes out as soon as the engine is started, even at idle speed.

F14

[170BF]

(1)

(2)

F15

[170BF]

(1)

(2)

(3)

(4)

F16

(1)

(2)

(3)

(4)

F17

[130BT]

[170BT/170BF]

(1)

(2)

(3)

(4)

F18

[130BT/170BT]

(1)

(2)

(3)

(5)

F19

[170BF]

F20

Operation