Husqvarna HA 110 用户手册

English

 – 11

There are three grease nipples on the gear housing. Use a 
grease gun to top up with grease. This should be carried out 
approximately every 20 working hours. Use Husqvarna 
special grease, part no. 503 98 96-01.

CAUTION! The gear housing must not be filled completely 
with grease. The grease expands as the machine heats up 
during operation. If the gear housing was completely filled 
with grease it could damage the seals and lead to leakage of 
grease.

The grease in the bevel gear does not normally need to be 
changed except if repairs are carried out.

After you have used the machine clean any resin and plant 
residue from the blades using cleaning agent 531 00 60-75 
(UL22).

Always lubricate the blade bars with special grease, part no. 
531 00 60-74 (UL 21) before use.

Below you will find some general maintenance instructions. If 
you need further information please contact your service 
workshop.

1

Check that the blades do not move when the engine is 
idling or when the choke is in the start throttle position.

2

Check that the hand guard is not damaged. Replace the 
guard if damaged. (HA 110)

1

Fill the gear housing with grease. This should be carried 
out approximately every 20 working hours.

2

Check that the screws that hold the blades together are 
correctly tightened.

Weight, Lbs/kg 

2,0

2,3

Length, mm

550

550

Blade speed, cuts/min

4184

4184