GE 42" 用户手册

• Raise the grille panel to the stop position.

• Remove 4 screws on bottom trim; retain 

all screws.

• Remove bottom trim.
• NOTE: Stainless steel and acrylic panels

are covered with a protective film. Remove
the film before installing the panel.

• Slide panel over the metal backer panel

and under the trim.

• If necessary, tap with a wood block until

panel slips under the top trim piece.

• Reassemble bottom trim. Tighten screws.

Raise
Grille
Panel

Whenever possible, perform this step for 
anti-tip security. 
The refrigerator must be secured to prevent
tipping.
• Raise the grille panel to access case trim.
• Drive a screw through the trim and into the

adjacent cabinet using holes provided.

• Follow the same procedure on the opposite

side.

Drive Screws

Through Case Trim Into

Adjacent Cabinets

Raise Grille Panel

to Stop Position

NOTE: This refrigerator has a 2-position door
stop. When space does not allow the door to
swing open fully to 130°, you may change the
door swing to a 90° opening. 
SKIP THIS STEP IF DOOR OPENING IS
SATISFACTORY FOR YOUR INSTALLATION
SITUATION. 
• Open the door to view the bottom hinge.

Note the door stop pin location. The pin is
factory installed in the 130° position. 

• Partially close the door. From above, use a

flat-head screwdriver to unscrew the door
stop pin and reinstall into the 90° position.

90

°

130

°

Hinge

Door

Interior