Panasonic AG-HMC40 用户指南

37

Make sure that the SD Memory Card 
ACCESS lamp is not flashing orange before 
opening the cover.

Do not remove the SD Memory Card or switch off 
the power in the following circumstances. Doing 
so may damage your SD Memory Card.

  1)  While the SD Memory Card ACCESS lamp is 

flashing orange after inserting an SD Memory 
Card.

  )  While the SD Memory Card ACCESS lamp 

is flashing during recording, recording 
finalization, and other operations.

Move the write-protect switch on the SD Memory 
Card to the “LOCK” position to prevent recorded 
contents being accidentally erased from the card.

•

•

Never remove the SD Memory Card or disconnect 

the battery or DC cable while the SD Memory 

Card ACCESS lamp is flashing, as doing so may 

damage the SD Memory Card. In the event the SD 

Memory Card is removed while the SD Memory 

Card access lamp is flashing, or the battery or 

DC cable is disconnected during a recording or 

recording finalization process, a repair verification 

screen will appear the next time the power is 

turned on to allow errors to be repaired.

Select YES to begin repairing. When repairing is 

complete, “REPAIR FINISHED” will be displayed, and 

the camera will switch to the recording paused screen.

Select NO to switch directly to the recording 

paused screen without repairing.

Memory cards cannot be repaired with the camera 

if NO is selected, but can still be repaired by using 

the AVCCAM Restorer∗ contents repair software.

An SD Memory Card on which an error occurred 

can be repaired by using either the camera 

that was used for the shooting, or the AVCCAM 

Restorer contents repair software.

A repair confirmation message may be displayed 

after inserting an SD Memory Card which has no 

error, but repair will not be performed even when 

YES or NO is selected.

Repair may take up to 0 minutes or so depending 

on the places where the errors occurred on the card.

Use a battery with an adequate charge or the AC adapter.

If the repair operation has failed, “SYSTEM 

ERROR TURN POWER OFF” will be displayed. 

In this case, please use the AVCCAM Restorer 

contents repair software. 

Depending on the status of the data, it may not be 

possible to restore all data completely. In this case, 

it will no longer be possible to play back the clips 

that were recorded before the SD Memory Card 

was ejected or the power was turned off. 

Clips with a total recording time of less than 10 

seconds may not be able to be repaired.

Shot marks added during recording cannot be 

repaired.

∗  AVCCAM Restorer is included on the supplied 

CD-ROM. For details on how to install it, refer to 

install.txt. 

For details on how to use it, read the operating 

instructions (PDF file). 

The AVCCAM Viewer can also be downloaded 

from the following website. 

https://eww.pavc.panasonic.co.jp/pro-av/

•

•

•

•

•

•

•

•