Enterasys csx400 用户指南
Configuration: DDS Service
Local Management User’s Guide
2-31
Proceed with the following steps:
1.
Use the arrow keys to highlight the WPIM X field at the bottom of the screen. Press the SPACE
bar to select the number of the WPIM being configured, then press ENTER.
bar to select the number of the WPIM being configured, then press ENTER.
2.
Use the arrow keys to highlight MgrType, and choose the Protocol Manager from PPP,
FR PtoMP, FR PtoP, or HDLC using the space bar to toggle the selections.
FR PtoMP, FR PtoP, or HDLC using the space bar to toggle the selections.
3.
Use the arrow keys to highlight DDS Line Mode. Press the SPACE bar to set the DDS Line
Mode to DDS-PRI or DDS-CC, then press ENTER.
Mode to DDS-PRI or DDS-CC, then press ENTER.
4.
Use the arrow keys to highlight DDS Tx Clock Source. Press the SPACE bar to set to
Loop-Timing, then press ENTER.
Loop-Timing, then press ENTER.
5.
Use the arrow keys to highlight DDS Loop-back. Press the SPACE bar to set to NONE, then
press ENTER.
press ENTER.
6.
Use the arrow keys to highlight the SAVE command. Then press ENTER. The message “SAVE
DONE!” displays and Local Management saves the changes to memory. “REBOOT IN
PROGRESS......” displays and the host platform reboots. Re-entry to management is necessary
for any further configuration.
DONE!” displays and Local Management saves the changes to memory. “REBOOT IN
PROGRESS......” displays and the host platform reboots. Re-entry to management is necessary
for any further configuration.
DDS Service Interface Configuration
The WAN Interface Configuration screen is accessed through the WAN Physical Configuration
screen. Access the WAN Interface Configuration screen (
screen. Access the WAN Interface Configuration screen (
) by using the arrow keys to
highlight the WAN INT CONFIG command, then press ENTER. Proceed with the following
steps to configure the WAN Interface through Local Management.
steps to configure the WAN Interface through Local Management.
1.
Use the arrow keys to highlight Interface Number. Set the WAN connection Interface Number
by typing the same number found in the Interface field on the WAN Physical Configuration
screen into the Interface Number field, then press ENTER.
by typing the same number found in the Interface field on the WAN Physical Configuration
screen into the Interface Number field, then press ENTER.
2.
If Frame Relay was selected, use the arrow keys to highlight FR LMI. Press the SPACE bar to
select ANSI_94, NO LMI, T1.617-D, or Q.933-A, then press ENTER.
select ANSI_94, NO LMI, T1.617-D, or Q.933-A, then press ENTER.
NOTE
When changing from one protocol to another on a WPIM-T1/DDS that has been
operational, save NONE as the protocol before changing to another protocol.
operational, save NONE as the protocol before changing to another protocol.