Lexmark W810 用户指南

Connectivity and network management

If you attach a Class 1 fax modem to the serial port on the tri-port card or MarkNet Pro 3 
print server, you can use the serial port to receive faxes. Most Class 1 brands are accept-
able.

An incoming fax is received on the serial port and routed to the printer, where it is printed. 
If someone tries to send a fax while the printer is busy, the phone rings but is not 
answered. The sender should wait and then try again. Outgoing faxes are not currently 
supported.

Note: In-bound fax is 

not supported through the serial interface adapter. See the 

following section for more information about this device.

This adapter attaches to the parallel port of the printer. You set baud, parity, and so on 
using physical switches on the adapter; no configuration is done through the printer 
menus. The printer is effectively unaware of the adapter, which provides an RS-232C 
25-pin D-shell female connector for serial cable attachment.

The serial interface adapter is supported in the following configurations:

9600 baud, no parity, 8 data bits, and 1 stop bit

19,200 baud, no parity, 8 data bits, and 1 stop bit

This adapter may be most useful where the printer needs to be attached both serially and 
via a network, such as Token-Ring or Ethernet.

Note: The serial adapter provides only unidirectional support. It has no NPA 

support.