Lexmark W810 安装指南

Set up network addresses

For instructions on other ways to set the IP address not documented 
in the following sections, refer to the 

Drivers, MarkVision and Utilities 

CD. Click 

 and then click 

.

You must assign an IP address, netmask, and gateway to the 
MarkNet print server for other network devices to find the printer on 
the network.

If you have DHCP, the proper address values are automatically 
assigned. To verify the assignment has happened, print a net-
work setup page and make sure the IP address, netmask, and 
gateway appear as non-zero.

If you don’t have DHCP, there are other methods you can use 
to manually assign the address, such as the printer operator 
panel, static ARP and telnet, RARP and telnet, BOOTP, or 
MarkVision or another Lexmark utility. Instructions for three of 
these methods follow.

You can use the printer operator panel to set the IP address, net-
mask, and gateway inside the print server. You must be standing at 
the printer to use this method.

Press 

 until you 

see the correct menu item, and 
then press 

.

 designates the network connector you are using for the print 

server. For example, 

 appears on the operator 

panel display if a MarkNet card is installed in network connec-
tor 2.

Press 

 to advance to the next segment in the address. 

Press 

 to increase the number by one. Press 

 to 

decrease the number by one.

Repeat steps 1 through 3 to