GE im4a 安装指导
REMOVE ICE CUBE TRAY SHELF
• Remove the two screws securing the ice cube tray
to the side wall of the freezer. Remove the tray.
• There are two white plug buttons above the screw
holes. Remove these plug buttons and install them
in the two screw holes that were used to hold the
ice cube tray shelf.
in the two screw holes that were used to hold the
ice cube tray shelf.
• Install two Phillips head screws (11) in the holes
that the plug buttons were in, but do not screw them
all the way in. The screw heads should extend about
1/2
all the way in. The screw heads should extend about
1/2
″ (13 mm) from the side wall of the freezer.
18
Installation Instructions
ICEMAKER INSTALLATION INSTRUCTIONS N
Are these the right instructions for your model? Follow the Installation Instructions indicated by
the label on the back of the refrigerator —
the label on the back of the refrigerator —
or S
R
Q
P
N
M
L
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
•
CAUTION –
Unplug
the Refrigerator. To eliminate the
danger of electric shock during
installation, you must unplug the
refrigerator from its electrical outlet.
danger of electric shock during
installation, you must unplug the
refrigerator from its electrical outlet.
Flat blade and Phillips
screwdrivers
Pliers
TOOLS YOU WILL NEED
Sharp knife
2
PREPARE FOR INSTALLATION
• Remove and discard the large white plug from
the rear freezer wall. Pull out the gray insulation
plug and remove any debris.
plug and remove any debris.
• Remove the outlet cover with a flat-blade
screwdriver.
1
Plug
Buttons
Buttons
11
INSTALL FILL TUBE
• Slide the fill tube with foil (14)
onto the water tube inlet (12),
making sure that the open side
of the fill tube faces up.
making sure that the open side
of the fill tube faces up.
• Go to the back of the refrigerator.
On the tube side of the water tube
inlet (12), there is an adhesive
backing. Remove the adhesive
backing and slide the tube into
the hole near the top at the back
of the refrigerator. Firmly press
on the inlet to secure it to
the refrigerator.
inlet (12), there is an adhesive
backing. Remove the adhesive
backing and slide the tube into
the hole near the top at the back
of the refrigerator. Firmly press
on the inlet to secure it to
the refrigerator.
• Install the water tube
inlet cover (17) over
the water tube inlet.
Secure the cover using
two hex-head screws (18).
the water tube inlet.
Secure the cover using
two hex-head screws (18).
3
12
14