Linksys dma2100 用户手册
Chapter 2
Network Setup and Extender Connections
14
Media Center Extender
14
Media Center Extender
Power on the Media Center Extender
NOTE:
Power on your TV.
DMA2200
Plug the Media Center Extender’s power cord connector to the unit’s
power port on the back panel. Plug the cord into an electrical outlet.
power port on the back panel. Plug the cord into an electrical outlet.
DMA2200
FOR HOME OFFICE USE
Tested
To Comply
With
FCC S
tandards
SCART IN/OUT
RESET
Power Switch
DMA2200 Power Cord and Switch
There is also an on/off power switch just above the power port. Power on
the unit before starting Device Configuration.
the unit before starting Device Configuration.
DMA2100
This unit ships with the correct power clip for your region.
DMA2100
Reset /
Default
Default
HDMI,
the HDMI
logo is a trademark or regi
stered tradema
Teste
d To Comply
With FCC Sta
ndards
Contains
FCC:N89-WM821-LS
FOR HOME OF
FICE USE
DMA2100 Power Cord
Plug the Media Center Extender’s power cord connector to the unit’s
power port on the back panel. Plug the cord into an electrical outlet.
power port on the back panel. Plug the cord into an electrical outlet.
Regional Power adapters
If needed, pull out the clip covering the power port connector. You can
then snap in the appropriate power clip that matches your main power
outlet. Power clips are used in Europe and Asia.
then snap in the appropriate power clip that matches your main power
outlet. Power clips are used in Europe and Asia.