Bosch ra1171 router table 用户手册

When using nonpiloted router bits, the fence is used to
set the depth of cut. For deep cuts, do not try to cut the
total depth all in one pass. Repeat the cut, taking
multiple smaller cuts. 

1. Install the desired bit in the router.
2. Follow the instructions on page 26 to set the desired

depth of cut and height of cut (Fig. 26). Make sure
that the fence and router are SECURELY in place.

3. Position both fence facings so that they clear the bit

by 1/4

″.

4. Tighten the four clamping knobs holding the fence

facings in place.

5. Position the featherboards, if desired. See 

ROUTING USING FEATHERBOARDS on page 25.

6. Remove the board from the table and lower the

NOTE: When making adjustments, use a piece of
scrap wood to make trial cuts before making the 
cut with the actual workpiece.

7. Make sure that both the router and switch box are

OFF; then plug the router into the switch box.

8. While firmly holding a piece of scrap wood

against the fence and down against the router
table, feed a piece of scrap wood toward the bit in
the direction shown by the arrow in Fig. 27.

9. Using the switch box, turn the router OFF. If any

adjustments are needed, unplug the power cord 
and repeat steps 2–8 until all adjustments are 
correct. Once you are satisfied with all settings,
make the cut with the actual workpiece.