Cisco me-4924-10ge 安装指导
2-10
Cisco ME 4924-10GE Ethernet Switch Hardware Installation Guide
OL-10071-01
Chapter 2 Switch Installation
Connecting to an SFP Module
Figure 2-6
Removing a Bale-Clasp Latch SFP Module by Using a Flat-Blade Screwdriver
Step 5
Grasp the SFP module between your thumb and index finger, and carefully remove it from the port.
Step 6
Place the removed SFP module in an antistatic bag or other protective environment.
Connecting to an SFP Module
This section describes how to connect to SFP modules. For instructions on how to connect to fiber-optic
SFP modules, see the
SFP modules, see the
section. For instructions on how to
section.
For instructions about how to install or remove an SFP module, see the
Connecting to a Fiber-Optic SFP Module
Follow these steps to connect a fiber-optic cable to an SFP module:
Caution
Do not remove the rubber plugs from the SFP module port or the rubber caps from the fiber-optic cable
until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables
from contamination and ambient light.
until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables
from contamination and ambient light.
Before connecting to the SFP module, be sure that you understand the port and cabling information in
the
the
and in the
.
See
module.
Step 1
Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.
Step 2
Insert one end of the fiber-optic cable into the SFP module port (see
).
Step 3
Insert the other cable end into a fiber-optic receptacle on a target device.
1
Bale clasp
PS1
PS2
FAN
154920
1