Alcatel-Lucent 6850-48 补充手册

Quick Steps for Setting Up An SNMP Management Station

Using SNMP

page 3-4

OmniSwitch AOS Release 6 Switch Management Guide

An SNMP Network Management Station (NMS) is a workstation configured to receive SNMP traps from 
the switch. To set up an SNMP NMS by using the switch’s CLI, proceed as follows:

1 Specify the user account name and the authentication type for that user. For example:

-> user NMSuserV3MD5DES md5+des password ********

2 Specify the UDP destination port number (in this case 8010), the IP address of the management station 
(199.199.100.200), a user account name (NMSuserV3MD5DES), and the SNMP version number (v3). For 
example:

Note: The user account must already be created as documented in Step 1 above. 

-> snmp station 199.199.100.200 8010 NMSuserV3MD5DES v3 enable

Use the same command as above for specifying the IPv6 address of the management station. For example:

-> snmp station 300::1 enable

Note. Optional. To verify the SNMP Management Station, enter the 

 command. The 

display is similar to the one shown here:

-> show snmp station

ipAddress/udpPort           status    protocol user

---------------------------+---------+--------+-------------------------------

199.199.100.200/8010        enable    v3       NMSuserV3MD5DES

199.199.101.201/111         disable   v2       NMSuserV3MD5

199.199.102.202/8002        enable    v1       NMSuserV3SHADES

-> show snmp station

ipAddress/udpPort                                   status    protocol user

---------------------------------------------------+---------+--------+------

172.21.160.32/4000                                  enable    v3       abc

172.21.160.12/5000                                  enable    v3       user1

0300:0000:0000:0000:0211:d8ff:fe47:470b/4001        enable    v3       user2

0300:0000:0000:0000:0211:d8ff:fe47:470c/5001        enable    v2       abc

For more information about this display, see the “SNMP Commands” chapter in the OmniSwitch CLI 
Reference Guide.