Alcatel-Lucent 6850-48 网络指南

Configuring IP Multicast Switching

Displaying IPMS Configurations and Statistics

OmniSwitch AOS Release 6 Network Configuration Guide

page 42-41

Alcatel-Lucent’s IP Multicast Switching (IPMS) show commands provide tools to monitor IPMS traffic 
and settings and to troubleshoot problems. These commands are described below:

If you are interested in a quick look at IPMS groups on your switch you could use the 

 command. For example:

-> show ip multicast group

Total 3 Groups

Group Address   Source Address  VLAN  Port  Mode     Static  Count  Life

---------------+---------------+-----+-----+--------+-------+------+-----

231.0.0.3       1.0.0.5         1     2/1   exclude  no      1      257

234.0.0.4       0.0.0.0         1     2/1   exclude  no      1      218

229.0.0.1       0.0.0.0         1     2/13  exclude  yes     0      0

Note. See the “IP Multicast Switching Commands” chapter in the OmniSwitch CLI Reference Guide for 
complete documentation on IPMS show commands.

Displays the general IP Multicast switching and routing configuration 
parameters on a switch.

Displays all detected multicast groups that have members. If you do not 
specify an IP address then all multicast groups on the switch will be dis-
played.

Displays all neighboring multicast routers.

Displays all multicast queriers.

Displays the IPMS multicast forwarding table. If you do not specify a 
multicast group IP address, then the forwarding table for all multicast 
groups will be displayed.

Displays the IPMS multicast source table. If you do not specify a multi-
cast group IP address, then the source table for all multicast groups will 
be displayed.

Displays the IP multicast switch and routing tunneling table entries 
matching the specified IP multicast group address, or all the entries if no 
IP multicast address is specified.