Alcatel-Lucent 6850-48 网络指南
Diagnosing Switch Problems
Switch Health Overview
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 45-13
Switch Health Defaults
The following table shows Switch Health default values.
Global Switch Health Defaults
Quick Steps for Configuring Switch Health
1 Display the health threshold limits, health sampling interval settings, and/or health statistics for the
switch, depending on the parameters you wish to modify. (For best results, note the default settings for
future reference.) For example:
switch, depending on the parameters you wish to modify. (For best results, note the default settings for
future reference.) For example:
-> show health threshold
The default settings for the command you entered will be displayed. For example:
Rx Threshold
= 80
TxRx Threshold
= 80
Memory Threshold
= 80
CPU Threshold
= 80
Temperature Threshold
= 60
2 Enter the appropriate command to change the required health threshold or health sampling interval
parameter settings or reset all health statistics for the switch. For example:
parameter settings or reset all health statistics for the switch. For example:
-> health threshold memory 85
Note. Optional. To verify the Switch Health configuration, enter
followed by the
parameter you modified (e.g., memory). The display is similar to the one shown below:
Memory Threshold
= 85
For more information about this command, see
or
the “Health Monitoring Commands” chapter in the OmniSwitch CLI Reference Guide.
Parameter Description
CLI Command
Default Value/Comments
Resource Threshold Limit Configuration
80 percent
Sampling Interval Configuration
5 seconds
Switch Temperature
50 degrees Celsius