Alcatel-Lucent 6850-48 网络指南
Diagnosing Switch Problems
Port Mirroring
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 45-19
In the following example, 1/2 through 1/6 and 1/9, 2/7, and 3/5 are mirrored on destination port 2/4 in
session 1:
session 1:
-> port mirroring 1 source 1/2-6 1/9 2/7 3/5 destination 2/4
Note. Ports can be added after a port mirroring session has been configured.
Unblocking Ports (Protection from Spanning Tree)
If the mirroring port monitors mirrored traffic on an RMON probe belonging to a different VLAN than the
mirrored port, it should be protected from blocking due to Spanning Tree updates. To create a mirroring
session that protects the mirroring port from being blocked (default) due to changes in Spanning Tree,
enter the
mirrored port, it should be protected from blocking due to Spanning Tree updates. To create a mirroring
session that protects the mirroring port from being blocked (default) due to changes in Spanning Tree,
enter the
CLI command and include the port mirroring session ID
number, source and destination slot/ports, and unblocked VLAN ID number, as shown in the following
example:
example:
-> port mirroring 6 source 2/3 destination 2/4 unblocked 750
This command line specifies mirroring session 6, with the source (mirrored) port located in slot 2/port 3,
and the destination (mirroring) port located in slot 2/port 4. The mirroring port on VLAN 750 is protected
from Spanning Tree updates.
and the destination (mirroring) port located in slot 2/port 4. The mirroring port on VLAN 750 is protected
from Spanning Tree updates.
Note. If the unblocked VLAN identifier is not specified, the mirroring port could be blocked due to
changes in Spanning Tree.
changes in Spanning Tree.
Enabling or Disabling Mirroring Status
Mirroring Status is the parameter using which you can enable or disable a mirroring session (i.e., turn port
mirroring on or off). There are two ways to do this:
mirroring on or off). There are two ways to do this:
• Creating a Mirroring Session and Enabling Mirroring Status or Disabling a Mirroring Session
(Disabling Mirroring Status). These procedures are described below and on the following page.
• Enabling or Disabling a Port Mirroring Session—“shorthand” versions of the above commands that
require fewer keystrokes. Only the port mirroring session ID number needs to be specified, rather than
the entire original command line syntax (e.g., source and destination slot/ports and optional unblocked
VLAN ID number). See
the entire original command line syntax (e.g., source and destination slot/ports and optional unblocked
VLAN ID number). See
for details.
Disabling a Mirroring Session (Disabling Mirroring Status)
To disable the mirroring status of the configured session between a mirrored port and a mirroring port
(turning port mirroring off), use the
(turning port mirroring off), use the
CLI command. Be sure to include
the port mirroring session ID number and the keyword disable.
In this example, the command specifies port mirroring session 6, with the mirrored (active) port located in
slot 2/port 3, and the mirroring port located in slot 6/port 4. The mirroring status is disabled (i.e., port
mirroring is turned off):
slot 2/port 3, and the mirroring port located in slot 6/port 4. The mirroring status is disabled (i.e., port
mirroring is turned off):
-> port mirroring 6 source disable