Alcatel-Lucent 6850-48 网络指南
Diagnosing Switch Problems
Monitoring Switch Health
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
page 45-47
Viewing Health Statistics for a Specific Interface
To view health statistics for slot 4/port 3, enter the show health command, followed by the appropriate
slot and port numbers. A screen similar to the following example will be displayed, as shown below:
slot and port numbers. A screen similar to the following example will be displayed, as shown below:
-> show health 4/3
* - current value exceeds threshold
Port 04/03
1 Min
1 Hr
1 Hr
Resources
Limit
Curr
Avg
Avg
Max
------------------+----------+--------+--------+---------+--------------------
Receive
80
01
01
01
01
Transmit/Receive
80
01
01
01
01
In the screen sample shown above, the port 04/03 Resources field displays the port resources that are
being measured (for example, Receive displays statistics for traffic received by the switch, while Trans-
mit/Receive displays statistics for traffic transmitted and received by the switch). The Limit field displays
currently configured resource threshold levels as percentages of available bandwidth. The Curr field
displays current bandwidth usage for the specified resource. 1 Min. Avg. refers to the average resource
bandwidth used over a 1 minute period. 1 Hr. Avg. refers to the average resource bandwidth used over a 1
hour period, and 1 Hr. Max. refers to the maximum resource bandwidth used over a 1 hour period.
being measured (for example, Receive displays statistics for traffic received by the switch, while Trans-
mit/Receive displays statistics for traffic transmitted and received by the switch). The Limit field displays
currently configured resource threshold levels as percentages of available bandwidth. The Curr field
displays current bandwidth usage for the specified resource. 1 Min. Avg. refers to the average resource
bandwidth used over a 1 minute period. 1 Hr. Avg. refers to the average resource bandwidth used over a 1
hour period, and 1 Hr. Max. refers to the maximum resource bandwidth used over a 1 hour period.
Resetting Health Statistics for the Switch
command cannot be used to clear statistics only for a specific module or port.
To reset health statistics for the switch, enter the health statistics reset command, as shown below:
-> health statistics reset