Alcatel-Lucent 6850-48 网络指南

Configuring GVRP

Configuring GVRP

page 5-12

OmniSwitch AOS Release 6 Network Configuration Guide

To allow dynamic VLAN registrations on the port, use the no form of the 

command as shown:

-> no gvrp restrict-vlan-registration port 3/1 4

Ports can be exempted from becoming members of statically created VLANs. To restrict a port from 
becoming a member of a statically configured VLAN, use the 

 command as 

shown:

-> gvrp static-vlan restrict port 1/2 5

Note. This command does not apply to dynamic VLANs.

Here, the port 1/2 is restricted from becoming a GVRP member of VLAN 5.

To restrict a port from becoming a member of a range of statically created VLANs, enter the

 command as shown:

-> gvrp static-vlan restrict port 1/2 5-9

Here, port 1/2 is restricted from becoming a GVRP member of VLANs 5 to 9.

A port can be allowed to become a member of statically created VLANs using the no form of the 

command. To allow port 3/1 to become a member of a statically created VLAN, 

enter the command as shown:

-> no gvrp static-vlan restrict 3/1

VLANs learned by a switch through GVRP can either be propagated to other switches or be blocked. This 
helps prune VLANs that have no members on a switch. If the applicant mode is set to participant or 
active, you can use the 

 command to restrict the propagation of VLAN 

information on a specified port as shown:

-> gvrp restrict-vlan-advertisement port 3/1 4

Here, VLAN 4 is not allowed to propagate on port 1 of slot 3.

To enable the propagation of dynamic VLANs on the specified port, use the no form of the command. To 
restrict VLAN 4 from being propagated to port 3/1, enter the command as shown:

-> no gvrp restrict-vlan-advertisement port 3/1 4