Alcatel-Lucent 6850-48 网络指南

Modifying Dynamic Link Aggregate Group Parameters

Configuring Dynamic Link Aggregation

page 23-22

OmniSwitch AOS Release 6 Network Configuration Guide

By default, the actor port priority (used to converge dynamic key changes) is 0. The following subsections 
describe how to configure a user-specified value and how to restore the value to its default value with the 

You can configure the actor port priority to a value ranging from 0 to 255 by entering lacp agg, the slot 
number, a slash (/), the port number, actor port priority, and the user-specified actor port priority.

For example, to modify the actor port priority of dynamic aggregate actor port 1 in slot 2 to 100 you would 
enter:

-> lacp agg 2/1 actor port priority 100

As an option, you can use the ethernet, fastethernet, and gigaethernet keywords before the slot and port 
number to document the interface type or make the command look consistent with early-generation 
Alcatel-Lucent CLI syntax. For example, to modify the actor port priority of dynamic aggregate actor port 
1 in slot 2 to 100 and document that the port is a Giga Ethernet port you would enter:

-> lacp agg gigaethernet 2/1 actor port priority 100

To remove a user configured actor port priority from a dynamic aggregate group actor port’s configura-
tion use the no form of the 

 command by entering lacp agg, the slot number, 

a slash (/), the port number, and no actor port priority.

For example, to remove a user-configured actor priority from dynamic aggregate actor port 1 in slot 2 you 
would enter:

-> lacp agg 2/1 no actor port priority