Alcatel-Lucent 6850-48 网络指南
Configuring IPMS on a Switch
Configuring IP Multicast Switching
page 42-10
OmniSwitch AOS Release 6 Network Configuration Guide
September 2009
-> ip multicast vlan 2 status
To restore the IP Multicast status to its default setting (i.e., disabled).
Enabling and Disabling IGMP Querier-forwarding
By default, IGMP querier-forwarding is disabled.The following subsections describe how to enable and
disable IGMP querier-forwarding by using the
disable IGMP querier-forwarding by using the
command.
Enabling the IGMP Querier-forwarding
the enable keyword. For example, to enable the IGMP querier-forwarding on the system if no VLAN is
specified, you would enter:
specified, you would enter:
-> ip multicast querier-forwarding enable
You can also enable the IGMP querier-forwarding on the specified VLAN by entering:
-> ip multicast vlan 2 querier-forwarding enable
Disabling the IGMP Querier-forwarding
You can disable the IGMP querier-forwarding by entering
the disable keyword. For example, to disable the IGMP querier-forwarding on the system if no VLAN is
specified, you would enter:
specified, you would enter:
-> ip multicast querier-forwarding disable
Or, as an alternative, enter:
-> ip multicast querier-forwarding
To restore the IGMP querier-forwarding to its default setting (i.e., disabled).
You can also disable the IGMP querier-forwarding on the specified VLAN by entering:
-> ip multicast vlan 2 querier-forwarding disable
Or, as an alternative, enter:
-> ip multicast vlan 2 querier-forwarding
To restore the IGMP querier-forwarding to its default setting (i.e., disabled).
You can remove an IGMP querier-forwarding entry on the specified VLAN and return to its default
behavior by entering:
behavior by entering:
-> no ip multicast vlan 2 querier-forwarding
Configuring and Restoring the IGMP Version
By default, the version of Internet Group Management Protocol (IGMP) membership is Version 2. The
following subsections describe how to configure IGMP protocol version ranging from 1 to 3 with the
following subsections describe how to configure IGMP protocol version ranging from 1 to 3 with the
command.