Alcatel-Lucent 6850-48 参考指南

Chassis Management and Monitoring Commands

page 2-28

OmniSwitch CLI Reference Guide

Clears the current saved slot information for a switch within a stacked configuration. When the saved slot 
information has been cleared via the stack clear slot command, the corresponding switch will 
automatically be assigned a unique slot number following a reboot.

stack clear slot slot-number

The current slot position used by the switch (1–8; 1001–1008). Note that 
the valid slot number range also includes slot positions 1001 through 
1008, reserved for switches in pass-through mode.

N/A

OmniSwitch 6400, 6850, 6855

• When the stack clear slot command is issued, the boot.slot.cfg file is immediately removed from the 

switch’s /flash directory. As a result, no slot assignment information will be found the next time the 
switch is booted. Because the switch’s slot will be considered undefined during the boot process, the 
switch is automatically assigned a unique slot number.

• Primary and secondary management modules cannot be forced into pass-through mode using the 

stack clear slot command. If the user attempts to force the secondary management module into pass-
through, the secondary switch will reboot and assume idle status when it comes back up. Meanwhile, 
an idle switch within the stack is selected and rebooted; when it comes up it assumes the secondary 
role.

-> stack clear slot 1002

-> stack clear slot 3

Release 6.1; command was introduced.