Alcatel-Lucent 6850-48 参考指南
MPLS LDP Commands
OmniSwitch CLI Reference Guide
September 2009
page 24-25
configure router ldp neighbor-liveness-time
Configures the Neighbor Liveness Time value for the local LDP router. This timer value specifies the
amount of time the router will wait for a neighboring router to re-establish an LDP session. If the neigh-
boring router fails to establish a session within this amount of time, the local router will delete the stale
label-forwarding equivalence class (FEC) bindings received from the neighboring router.
amount of time the router will wait for a neighboring router to re-establish an LDP session. If the neigh-
boring router fails to establish a session within this amount of time, the local router will delete the stale
label-forwarding equivalence class (FEC) bindings received from the neighboring router.
configure router ldp neighbor-liveness-time seconds
configure router ldp no neighbor-liveness-time
Syntax Definitions
seconds
The Maximum Recovery Time value, in seconds. The valid range is
from 5–300.
from 5–300.
Defaults
By default, the Neighbor Liveness Time is set to 120 seconds.
Platforms Supported
OmniSwitch 9000E
Usage Guidelines
• Use the no form of this command to set the Neighbor Liveness Time to the default value.
• If the neighboring router advertises a Reconnect Time that is less than the local Neighbor Liveness
Time value, then the local router uses the Recovery Time to determine how long to wait for the neigh-
bor to re-establish the LDP session.
bor to re-establish the LDP session.
Examples
-> configure router ldp neighbor-liveness-time 300
-> configure router ldp no neighbor-liveness-time
Release History
Release 6.4.2; command was introduced.