Alcatel-Lucent 6850-48 参考指南

MPLS Static LSP and FRR Commands

page 25-14

OmniSwitch CLI Reference Guide

Configures a static Label Switched Path (LSP) instance on an ingress Label Edge Router (LER).

configure router mpls static-lsp lsp-name

configure router mpls no static-lsp lsp-name

An alphanumeric name, up to 32 characters, to assign to the static LSP.

N/A

OmniSwitch 9000E

• To remove this static LSP configuration from the ingress router, administratively disable (shutdown) 

the LSP and then use the no form of this command to remove the configuration from the router.

• The Static LSP instance is identified by the LSP name on the ingress router and by the MPLS interface 

name and ingress label combination on both transit and egress routers.

• Configuring the static LSP instance is done only on the ingress LER to identify the origination point of 

the LSP. 

• Once the static LSP is created and associated with a name, configuring the destination IP address, the 

push operation, and the next-hop router IP address for the LSP is required. 

-> configure router mpls static-lsp to-R3

-> configure router mpls no static-lsp to-R3

Release 6.4.2; command was introduced.

Configures the administrative status of the static LSP.

Configures the destination System IP address for the static LSP.

Pushes the specified label on to the label stack and specifies the IP 
address for the next-hop router in the static LSP.

Displays static LSP configuration information.