Alcatel-Lucent 6850-48 参考指南

Virtual Private LAN Service (VPLS) Commands

OmniSwitch CLI Reference Guide

page 26-23

Configures a static Label Switched Path (LSP) association with the specified Service Distribution Point 
(SDP). A static LSP is a user-configured path through Label Switching Routers (LSRs). Each participat-
ing LSR in the path requires manual configuration of MPLS actions and label mappings. However, assso-
ciating a static LSP with an SDP is only done on the SDP router.

configure service sdp sdp-ip lsp lsp-name

configure service sdp sdp-ip no lsp lsp-name

An existing SDP ID number.

The name of an existing static LSP to assign to the SDP ID.

N/A.

OmniSwitch 9000E

• Use the no form of this command to disable the static LSP association with the specified SDP.

• There are two types of LSPs: LDP and static. This command attaches a static LSP to a SDP. See 

 for more information.

• LDP and static LSPs are mutually exclusive for the same SDP. If LDP is enabled for the SDP, disable 

LDP first before attempting to configure a static LSP for the SDP. The reverse is also true; disable any 
static LSPs associated with the SDP before attempting to enable LDP for the SDP.

• Configuring LSPs is only allowed when the SDP is administratively disabled.

• The specifed SDP must have LDP signaling enabled if the SDP is going to use LDP-signaled LSPs.

• The static LSPs associated with an SDP must terminate at the same far-end router IP address used by 

the SDP. 

-> configure service sdp 10 lsp to-r4

-> configure service sdp 10 no lsp to-r4

Release 6.4.2; command was introduced.