Alcatel-Lucent 6850-48 参考指南

IPv6 Commands

page 33-26

OmniSwitch CLI Reference Guide

Tests whether an IPv6 destination can be reached from the local switch. This command sends an ICMPv6 
echo request to a destination and then waits for a reply. To ping a destination, enter the ping6 command 
and enter either the destination’s IPv6 address or hostname. The switch will ping the destination using the 
default frame count, packet size, and interval (6 frames, 64 bytes, and 1 second respectively). You can also 
customize any or all of these parameters as described below.

ping6 {ipv6_address | hostname} [if_name] [count count] [size data_size] [interval seconds] 

IP address of the system to ping.

DNS name of the system to ping.

If the target is a link-local address, the name of the interface used to 
reach it.

Number of packets to be transmitted.

Size of the data portion of the packet sent for this ping, in bytes.

Interval, in seconds, at which ping packets are transmitted.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• If you change the default values, they will only apply to the current ping. The next time you use the 

ping command, the default values will be used unless you again enter different values.

• When the next hop address is a local link address, the name of the interface used to reach the destina-

tion must be specified.

6

56

interval seconds

1