Alcatel-Lucent 6850-48 参考指南
IPv6 Commands
OmniSwitch CLI Reference Guide
September 2009
page 33-77
ipv6 rip holddown-timer
Configures the amount of time a route is placed in a holddown state. Whenever a route is seen from the
same gateway with a higher metric than the route in RIB, the route goes into holddown. This excludes
route updates with an INFINITY metric.
same gateway with a higher metric than the route in RIB, the route goes into holddown. This excludes
route updates with an INFINITY metric.
ipv6 rip holddown-timer seconds
Syntax Definitions
seconds
Time, in seconds, that a route will remain in a holddown state. Valid
range is 0 - 120.
range is 0 - 120.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
While in holddown, the route continues being announced as usual and used in RIB. This interval is used to
control route flap dampening.
control route flap dampening.
Examples
-> ipv6 rip holddown-timer 60
Release History
Release 6.1; command was introduced.
Related Commands
MIB Objects
alaProtocolripng
alaRipngHolddownTimer
parameter
default
seconds
0
Configures the amount of time a route remains active in RIB before
being moved to the "Garbage" state.
being moved to the "Garbage" state.
Configures the RIPng garbage timer value.