Alcatel-Lucent 6850-48 参考指南
RIP Commands
OmniSwitch CLI Reference Guide
September 2009
page 37-3
ip rip status
Enables/disables RIP on the switch. RIP performs well in small networks. By default, RIP packets are
broadcast every 30 seconds, even if no change has occurred anywhere in a route or service. Depending on
the size and speed of the network, these periodic broadcasts can consume a significant amount of band-
width.
broadcast every 30 seconds, even if no change has occurred anywhere in a route or service. Depending on
the size and speed of the network, these periodic broadcasts can consume a significant amount of band-
width.
ip rip status {enable | disable}
Syntax Definitions
enable
Enables RIP routing on the switch.
disable
Disables RIP routing on the switch.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• RIP must be loaded on the switch (
) to enable RIP on the switch.
• A RIP network can be no more than 15 hops (end-to-end). If there is a 16th hop, that network is identi-
fied as infinity and the packet is discarded.
Examples
-> ip rip status enable
Release History
Release 6.1; command was introduced.
Related Commands
MIB Objects
alaProtocolRip
alaRipProtoStatus
parameter
default
enable | disable
disable
Loads RIP into the switch memory.
Displays the RIP status and general configuration parameters (e.g.,
forced hold-down timer).
forced hold-down timer).