Alcatel-Lucent 6850-48 参考指南
RIP Commands
page 37-8
OmniSwitch CLI Reference Guide
September 2009
ip rip interface metric
Configures the RIP metric or cost for a specified interface. You can set priorities for routes generated by a
switch by assigning a metric value to routes generated by that switch’s RIP interface. For example, routes
generated by a neighboring switch may have a hop count of 1. However, you can lower the priority of
routes generated by that switch by increasing the metric value for routes generated by the RIP interface.
switch by assigning a metric value to routes generated by that switch’s RIP interface. For example, routes
generated by a neighboring switch may have a hop count of 1. However, you can lower the priority of
routes generated by that switch by increasing the metric value for routes generated by the RIP interface.
ip rip interface {interface_name} metric value
Syntax Definitions
interface_name
The name of the interface.
value
Metric value. Valid range is 1–15.
Defaults
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
When you configure a metric for a RIP interface, this metric cost is added to the metric of the incoming
route.
route.
Examples
-> ip rip interface rip-1 metric 2
Release History
Release 6.1; command was introduced.
Release 6.2.1; ip_address parameter deprecated.
Release 6.2.1; ip_address parameter deprecated.
Related Commands
MIB Objects
rip2IfConfTable
rip2IfConfAddress
rip2IfConfDefaultMetric
parameter
default
value
1
Enables/disables RIP on a specific interface.
Displays active RIP neighbors (peers). An active peer is a switch
that has sent a RIP packet within the last 180 seconds.
that has sent a RIP packet within the last 180 seconds.