Alcatel-Lucent 6850-48 参考指南

VRRP Commands

page 40-46

OmniSwitch CLI Reference Guide

Displays the default parameter values for all the virtual router groups or for a specific virtual router group.

show vrrp group [vrgid]

The virtual router group ID, in the range from 1–255.

By default, the default parameter values are displayed for all the virtual router groups.

OmniSwitch 6850, 6855, 9000, 9000E

Use the vrgid parameter with this command to display the default values for a specific virtual router group.

-> show vrrp group 2

Virtual Router Group GROUPID = 2

  Interval = 11

  Priority = 250

  Preempt Mode = Yes

  3 Associated Virtual Routers

Release 6.3.1; command was introduced. 

The virtual router group identifier.

Indicates the time interval, in seconds, between the sending of 
advertisement messages. Only the master router sends advertisements.

Indicates the VRRP router’s priority for the virtual router group. For 
more information about priority, see the 

 command description on 

.

Controls whether a higher priority virtual router will preempt a lower 
priority master; preempt indicates that a higher priority virtual router 
will preempt a lower priority master; no preempt indicates that the first 
backup router to take over for the master will not be preempted by a 
virtual router with a higher priority. In either case, the IP address owner 
will always take over it if is available.