Alcatel-Lucent 6850-48 参考指南
Network Time Protocol Commands
page 5-26
OmniSwitch CLI Reference Guide
September 2009
show ntp client server-list
Displays a list of the servers with which the NTP client synchronizes.
show ntp client server-list
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
Use this command to display tabular information on the current NTP client to server association status.
Examples
-> show ntp client server-list
IP Address Ver Key St Delay Offset Disp
================+===+=======+====+==========+=================+==========
*198.206.181.70 4 0 2 0.167 0.323 0.016
=198.206.181.123 4
0 16
0.000
0.000
0.000
output definitions
IP Address
The server IP address.
"+" indicates an active peer
"-" indicates a pasive peer
"=" indicates a client
"*" indicates current system peer
"^" indicates a broadcast server
"`" indicates a broadcast client
"+" indicates an active peer
"-" indicates a pasive peer
"=" indicates a client
"*" indicates current system peer
"^" indicates a broadcast server
"`" indicates a broadcast client
Ver
The version of NTP the server is using. Versions 3 and 4 are valid.
Key
The NTP server’s public key. This must be accurate and the same as the
NTP server, or the client switch will not be able to synchronize with the
NTP server. A zero (0) means there is no key entered.
NTP server, or the client switch will not be able to synchronize with the
NTP server. A zero (0) means there is no key entered.
St
The stratum of the server.
Delay
The delay received from the server in its timestamp.
Offset
The offset received from the server in its timestamp.
Disp
The dispersion value received from the server in its timestamp.