Alcatel-Lucent 6850-48 参考指南
OSPFv3 Commands
page 42-40
OmniSwitch CLI Reference Guide
September 2009
show ipv6 ospf area
Displays either all OSPFv3 areas, or a specified OSPFv3 area.
show ipv6 ospf area [area_id]
Syntax Definitions
area_id
A unique 32-bit value in IP address format.
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
• Allows you to view the details of a specified OSPFv3 area.
• If an OSPF area is not specified, all known areas for the OSPFv3 router will be displayed.
• See the Related Commands section below for information on modifying an area.
Examples
-> show ipv6 ospf area
Stub Number of
Area ID Type Metric Interfaces
----------------+-------+-------+-------------
0.0.0.0 Normal NA 2
0.0.0.1 Normal NA 2
-> show ipv6 ospf area 0.0.0.0
Area Type = Normal,
Area Stub Metric = 0,
# of SPF calculations = 52,
# Interfaces = 3,
# Router LSAs = 2,
# Network LSAs = 3,
# Intra-area-prefix LSAs = 4,
# Inter-area-prefix LSAs = 15,
# Inter-area-router LSAs = 0,
# hosts = 0,
output definitions
Area Type
The area type. This field will be normal or stub.
Area Stub Metric
Indicates whether the area is enabled or disabled.
# Router LSAs
The total number of Link State Advertisements for the Area.