Alcatel-Lucent 6850-48 参考指南
BGP Commands
OmniSwitch CLI Reference Guide
September 2009
page 44-175
show ip bgp neighbors timer
Displays BGP peer timer statistics.
show ip bgp neighbors timer [ip_address]
Syntax Definitions
ip_address
A 32-bit IP address.
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
This command displays the timer values for all peer associated with this speaker, or for a specific peer.
Examples
-> show ip bgp neighbors timer
Legends: Nbr = Neighbor
As = Autonomous System
RtAdv = Route Advertisement
Kalive = Keep Alive (actual)
Ka(C) = Configured Keep Alive
Nbr address As Hold Hold(C) RtAdv Retry Kalive Ka(C)
---------------+-----+-----+-------+-----+-----+------+-----
192.40.4.29 3 90 90 30 120 30 30
192.40.4.121 5 0 90 30 120 0 30
output definitions
Nbr address
The IP address for this BGP peer. Assign this address through the
command.
As
The autonomous system to which this peer belongs. A peer’s AS num-
ber is assigned through the
ber is assigned through the
command.
Hold
The current count for the holdtime value.
Hold(C)
The holdtime value configured through the
command.
RtAdv
The route advertisement interval, in seconds, for updates between
external BGP peers. This value is configured through the
external BGP peers. This value is configured through the
Retry
The interval, in seconds, between retries by this peer to set up a con-
nection via TCP with another peer. This value is configured through
the
nection via TCP with another peer. This value is configured through
the
command.