Alcatel-Lucent 6850-48 参考指南

PIM Commands

OmniSwitch CLI Reference Guide

page 45-15

Configures the local router as the Candidate-Rendezvous Point (C-RP) for a specified IP multicast 
group(s).

ip pim candidate-rp rp_address group-address/prefix_length [priority priority] [interval seconds] 

no ip pim candidate-rp rp_address group-address/prefix_length

Specifies a 32-bit address that will be advertised as a Candidate-RP.

Specifies a 32-bit group address for which the local router will adver-
tise itself as a Candidate-RP.

Specifies the prefix length of the multicast group.

Specifies the priority value of the Candidate-RP. Values may range 
from 0 to 192. The lower the value, the higher the priority.

Specifies the interval at which the C-RP advertisements are sent to the 
Bootstrap router, in seconds. Values may range from 1 to 300.

OmniSwitch 6850, 6855, 9000, 9000E

• Use the no form of this command to remove the association of the device as a C-RP for a particular 

multicast group.

• The specified rp_address must belong to a PIM enabled interface.

• Only one RP address is supported per switch. If multiple candidate-RP entries are defined, they must 

specify the same rp-address.

• The priority and the interval values are used by the switch. If they are modified for one entry, the 

switch will modify these for all the candidate-rp entries.

• This command is supported only in the sparse mode.

-> ip pim candidate-rp 50.1.1.1 224.0.0.0/4 priority 100 interval 100

192

60