Alcatel-Lucent 6850-48 参考指南
DVMRP Commands
OmniSwitch CLI Reference Guide
September 2009
page 46-25
show ip dvmrp
Displays the global DVMRP parameters.
show ip dvmrp
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
N/A
Examples
-> show ip dvmrp
DVMRP Admin Status = enabled,
Flash Interval = 5,
Graft Timeout = 5,
Neighbor Interval = 10,
Neighbor Timeout = 35,
Prune Lifetime = 7200,
Prune Timeout = 30,
Report Interval = 60,
Route Holddown = 120,
Route Timeout = 140,
Subord Default = true,
Number of Routes = 2,
Number of Reachable Routes = 2
output definitions
DVMRP Admin Status
The current global (i.e., switch-wide) status of DVMRP, which can be
enabled or disabled. To change the current DVMRP global status,
refer to the
enabled or disabled. To change the current DVMRP global status,
refer to the
Flash Interval
The current minimum flash update interval value, in seconds. The flash
interval defines how often routing table change messages are sent to
neighboring DVMRP routers. Because routing table change messages
are sent between the transmission of complete routing tables, the flash
update interval must be shorter than the route report interval. The
default value is 5.
interval defines how often routing table change messages are sent to
neighboring DVMRP routers. Because routing table change messages
are sent between the transmission of complete routing tables, the flash
update interval must be shorter than the route report interval. The
default value is 5.