Alcatel-Lucent 6850-48 参考指南
OmniSwitch CLI Reference Guide
September 2009
page 52-1
52 QoS Commands
Alcatel-Lucent’s QoS software provides a way to manipulate flows coming through the switch based on
user-configured policies. The flow manipulation (generally referred to as Quality of Service or QoS) may
be as simple as allowing/denying traffic, or as complicated as remapping 802.1p bits from a Layer 2
network to ToS values in a Layer 3 network.
user-configured policies. The flow manipulation (generally referred to as Quality of Service or QoS) may
be as simple as allowing/denying traffic, or as complicated as remapping 802.1p bits from a Layer 2
network to ToS values in a Layer 3 network.
This chapter provides information about configuring QoS global and port parameters through the
Command Line Interface (CLI). Refer to
Command Line Interface (CLI). Refer to
for information about
commands used to configure QoS policy rules.
MIB information for the QoS commands is as follows:
Filename: alcatelIND1Qos.mib
Module
Module
ALCATEL-IND1-QoS-MIB
Important Note. Some of the commands listed here are not currently supported on one or more plat-
forms. See command descriptions in this chapter and check release notes for information about commands
that are not supported.
forms. See command descriptions in this chapter and check release notes for information about commands
that are not supported.