Alcatel-Lucent 6850-48 参考指南

QoS Policy Commands

OmniSwitch CLI Reference Guide

page 53-161

Specifies a destination port for a hypothetical packet to show how the QoS software in the switch will 
handle the packet.

show policy classify {l2 | l3 | multicast} [applied] destination port slot/port

Uses the Layer 2 classifier for the hypothetical packet.

Uses the Layer 3 classifier for the hypothetical packet. 

Uses the multicast IGMP classifier for the hypothetical packet. 

Indicates that only applied policies should be examined. 

The slot and port number of the destination address of the flow.

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use this command to determine if the switch will classify the traffic condition specified and match it to 

a policy. By default the classifier only tests pending policies (policies that have not yet been applied). 
Use the applied keyword to test only those policies that have been applied.

• Use the qos apply command to activate saved policies.

-> show policy classify l2 destination port 2/1

See the output example given on 

 for more information about the potential screen display.

Release 6.1; command was introduced.

Applies configured QoS and policy settings to the current configuration. 

Describes the base command.