Alcatel-Lucent 6850-48 参考指南
QoS Policy Commands
OmniSwitch CLI Reference Guide
September 2009
page 53-169
show policy classify destination vlan
Specifies a destination VLAN for a hypothetical packet to show how the QoS software in the switch will
handle the packet.
handle the packet.
show policy classify {l2 | l3 | multicast} [applied] destination vlan vlan_id
Syntax Definitions
l2
Uses the Layer 2 classifier for the hypothetical packet.
l3
Uses the Layer 3 classifier for the hypothetical packet.
multicast
Uses the multicast IGMP classifier for the hypothetical packet.
applied
Indicates that only applied policies should be examined.
vlan_id
The destination VLAN ID for the flow.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
Use the applied keyword to test only those policies that have been applied.
• Use the qos apply command to activate saved policies.
Examples
-> show policy classify l2 destination vlan 3
for more information about the potential screen display.
Release History
Release 6.1; command was introduced.