Alcatel-Lucent 6850-48 参考指南
QoS Policy Commands
page 53-184
OmniSwitch CLI Reference Guide
September 2009
show policy classify dscp
Specifies a DiffServ Code Point (DSCP) value for a hypothetical packet to show how the QoS software in
the switch will handle the packet.
the switch will handle the packet.
show policy classify {l2 | l3 | multicast} [applied] dscp dscp_value
Syntax Definitions
l2
Uses the Layer 2 classifier for the hypothetical packet.
l3
Uses the Layer 3 classifier for the hypothetical packet.
multicast
Uses the multicast IGMP classifier for the hypothetical packet.
applied
Indicates that only applied policies should be examined.
dscp_value
The DiffServ Code Point value, in the range 0–63.
Defaults
N/A
Platforms Supported
OmniSwitch 6400, 6850, 6855, 9000, 9000E
Usage Guidelines
• Use this command to determine if the switch will classify the traffic condition specified and match it to
a policy. By default the classifier only tests pending policies (policies that have not yet been applied).
Use the applied keyword to test only those policies that have been applied.
Use the applied keyword to test only those policies that have been applied.
• Use the qos apply command to activate policies.
• If a DSCP value is specified, a ToS value may not be specified.
Examples
-> show policy classify l3 dscp 63
for more information about the potential screen display.
Release History
Release 6.1; command was introduced.