Alcatel-Lucent 6850-48 参考指南

IP Multicast Switching Commands

page 55-46

OmniSwitch CLI Reference Guide

Enables or disables IPv6 Multicast Switching and Routing on the specified VLAN or on the system if no 
VLAN is specified.

ipv6 multicast [vlan vid] status [{enable | disable}]

VLAN on which to apply the configuration.

Enable IPv6 Multicast Switching and Routing.

Disable IPv6 Multicast Switching and Routing.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• If an IPv6 multicast routing protocol is already running on the system, the ipv6 multicast status 

command will override this configuration and always enable IPv6 Multicast Switching and Routing.

• If the IPv6 Multicast Switching and Routing is already enabled on the system, then the VLAN configu-

ration will override the system's configuration.

• You can also restore the MLD querying to its default (i.e., disabled) status on the system if no VLAN is 

specified, by using only ipv6 multicast status (e.g., ipv6 multicast status).

• You can also restore the MLD querying to its default (i.e., disabled) status on the specified VLAN, by 

using only ipv6 multicast vlan vid status (e.g., ipv6 multicast vlan 2 status).

-> ipv6 multicast status enable

-> ipv6 multicast status disable

-> ipv6 multicast status

-> ipv6 multicast vlan 2 status enable

-> ipv6 multicast vlan 2 status disable

-> ipv6 multicast vlan 2 status

Release 6.1.1; command was introduced.