Alcatel-Lucent 6850-48 参考指南

IP Multicast VLAN Commands

page 56-10

OmniSwitch CLI Reference Guide

Configures a port, a range of ports, or an aggregate of ports as receiver ports for the IP Multicast VLAN.

vlan ipmvlan ipmvlan-id receiver-port {port slot/port[-port2] | linkagg agg_num [-agg_num2]}

no vlan ipmvlan ipmvlan-id receiver-port {port slot/port[-port2] | linkagg agg_num [-agg_num2]}

Specifies the IP Multicast VLAN number to which the port will be 
attached as a receiver port. The valid range is 2–4094.

slot/port

The slot number for the module and physical port number on that 
module (e.g., 3/1 specifies port 1 on slot 3).

Last port number in a range of ports you want to configure on the same 
slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).

The link aggregate ID number to be assigned as a receiver port to the 
specified IPMVLAN. The valid range is 0–31.

Last link aggregate ID number in a range of aggregates you want to 
configure.

N/A

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to remove the port assigned as a receiver port for the IPMVLAN.

• A single port can be configured as a receiver port for multiple IPMVLANs as long as the IPMVLANs 

are not associated with the same address. An IPMVLAN can contain multiple receiver ports.

• In the Enterprise mode, the configuration fails if the port configured as a receiver port is an aggregated 

port (member port of a logical aggregate) or a VLAN Stacking port.

• In the VLAN Stacking mode, the configuration fails if the port configured as a receiver port is not a 

VLAN Stacking user port.

The following commands configure the receiver port in the Enterprise mode:

-> vlan ipmvlan 1003 receiver-port port 1/51-60 

-> vlan ipmvlan 1033 receiver-port port 1/62