Alcatel-Lucent 6850-48 参考指南
Network Security Commands
page 61-2
OmniSwitch CLI Reference Guide
September 2009
netsec group port
Creates a monitoring-group and configures port associations for that group.
netsec group grp_name port slot/port[-port2]
no netsec group grp_name port slot/port[-port2]
Syntax Definitions
grp_name
The name of the monitoring-group (up to 32 characters).
slot/port
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
module (e.g., 3/1 specifies port 1 on slot 3).
port2
The last port number in a range of ports that you want to associate on
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
the same slot (e.g, 3/1-4 specifies ports 1-4 on slot 3).
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 9000, 9000E
Usage Guidelines
• Use the no form of this command to remove a port or a range of ports from the monitoring-group.
• A port-range cannot be a subset of any other port-range which is already configured.
• The word ‘all’ cannot be used as a group name (grp_name).
Examples
-> netsec group ad-port port 1/1
-> netsec group ad-port port 1/3-10
-> no netsec group ad-port port 1/1
Release History
Release 6.3.1; command was introduced.
Related Commands
Configures the monitoring period of an anomaly for a port-group,
packet count configuration for triggering anomaly detection, anomaly
detection algorithm’s sensitivity to discrepancy in standard and
observed traffic pattern.
packet count configuration for triggering anomaly detection, anomaly
detection algorithm’s sensitivity to discrepancy in standard and
observed traffic pattern.
Displays the anomaly check summary.