Alcatel-Lucent 6850-48 参考指南

Link Aggregation Commands

OmniSwitch CLI Reference Guide

page 12-37

Configures the partner system priority for a dynamic aggregate group port.

lacp agg [ethernet | fastethernet | gigaethernet] slot/port partner admin system priority 
partner_admin_system_priority

lacp agg [ethernet | fastethernet | gigaethernet] slot/port no partner admin system priority

Documents that the port is 10 Mbps Ethernet.

Documents that the port is 100 Mbps Fast Ethernet.

Documents that the port is Gigabit Ethernet.

The slot number for this aggregate.

The port that the switch will initially use as the Spanning Tree virtual 
port for this aggregate.

The priority of the remote switch’s dynamic aggregate group to which 
the aggregation group is attached. Possible values are 0–255.

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to remove a partner_system_priority value from a slot and port asso-

ciated with a dynamic aggregate group.

• The ethernet, fastethernet, and gigaethernet keywords do not modify a port’s configuration. See 

 for information on CLI commands to configure Ethernet 

ports.

-> lacp agg 2/1 partner admin system priority 65

-> lacp agg 2/1 no partner admin system priority

Release 6.1; command was introduced.

0