Alcatel-Lucent 6850-48 参考指南

Ethernet Ring Protection Commands

page 16-8

OmniSwitch CLI Reference Guide

Configures a switch as a Ring Protection Link (RPL) node. This command also identifies the ERP port as 
an RPL connection port. The RPL remains blocked to prevent loops within the ERP ring.

erp-ring ring_id rpl-node {port slot/port | linkagg agg_num} 

no erp-ring ring_id rpl-node

An existing ERP ring ID number. The valid range is 1- 2147483647.

The slot number for the module and the physical port number on that 
module.

The link aggregate ID number.

NA

OmniSwitch 6400, 6850, 6855, 9000, 9000E

• Use the no form of this command to remove the RPL designation for the specified ring.

• The RPL node can be configured only when the ring is disabled; RPL configuration applied to the ring 

while it is enabled will be rejected.

• The specified ERP ring ID must already exist in the switch configuration.

• This command applies only to ERP ring ports; ports not configured as ERP ring ports are not eligible to 

become RPL ports. 

• Only one of the two ring ports configured for the switch can be designated as an RPL node port.

-> erp-ring 1 rpl-node port 2/1

-> erp-ring 2 rpl-node linkagg 2

-> no erp-ring 2 rpl-node

Release 6.3.4; command was introduced.